![]() ![]() ![]() Then start again.? is any way to see where are the values saved in the mill.? if i turn of the mill, the next time is necesary run the program above, before to run auto tool lenght.? o that info is stored in the mill. why.? i dont know, im agree with you about, should work with all cycle. ![]() Then try to do automatic lenght and diameter, start with tool 1, from the home posiotion run VQC select Automatic Lenght and Diameter, the machine move but the spindle stop 10mm up the top os the stylus (ok) but is out of the center. run the program and the spindle move to the top and center of the stylus, touch the top of the stylus and add the value to the tool offset, work fine, do the same with tool 4 work fine, do the same with tool 5 work fine, all the tools move from the home. Now move the machine to home position, and run VQC to see if the Automatic lenght work. North Hills / Water Dam / on top of water dam entrance on the middle shelf. Radar / a building in the northern-most location, right next to Damned entrance. Matt, i run the program like you said, the pin in the spindle touch first on the top of the stylus, then, right, then left, then front, then back and finish with the pin on the top of the stylus 10 mm up and centered. Known locations for this item starting with v1.4007 are: Radar / a building to the right of the entrance to the complex, on the lower shelf. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |